External Memory Interface Handbook Volume 1: Intel® FPGA Memory Solution Introduction and Design Flow: For UniPHY-based Device Families

Download PDF
ID 710283
Date 3/06/2023
Public
Document Table of Contents
Document Table of Contents x
1. Introduction to this Handbook 2. Recommended Design Flow 3. Selecting Your Memory 4. Selecting Your FPGA Device
1. Introduction to this Handbook x
1.1. Introduction to Memory Solutions 1.2. Protocol Support Matrix 1.3. Document Revision History
2. Recommended Design Flow x
2.1. Getting Started With External Memory Interfaces 2.2. Document Revision History
2.1. Getting Started With External Memory Interfaces x
2.1.1. Selecting Your External Memory Device 2.1.2. Selecting Your FPGA 2.1.3. Planning Your Pin Requirements 2.1.4. Planning Your FPGA Resources 2.1.5. Determining Your Board Layout 2.1.6. Specifying Parameters for Your External Memory Interface 2.1.7. Performing Functional Simulation 2.1.8. Adding Design Constraints 2.1.9. Compiling Your Design and Verifying Timing 2.1.10. Verifying and Debugging External Memory Interface Operation
3. Selecting Your Memory x
3.1. DDR SDRAM Features 3.2. DDR2 SDRAM Features 3.3. DDR3 SDRAM Features 3.4. QDR, QDR II, and QDR II+ SRAM Features 3.5. RLDRAM II and RLDRAM 3 Features 3.6. LPDDR2 Features 3.7. Memory Selection 3.8. Example of High-Speed Memory in Embedded Processor 3.9. Example of High-Speed Memory in Telecom 3.10. Document Revision History
4. Selecting Your FPGA Device x
4.1. Memory Standards 4.2. I/O Interfaces 4.3. Wraparound Interfaces 4.4. Read and Write Leveling 4.5. Dynamic OCT 4.6. Device Settings Selection 4.7. Document Revision History
4.6. Device Settings Selection x
4.6.1. Device Speed Grade 4.6.2. Device Operating Temperature 4.6.3. Device Package Size 4.6.4. Device Density and I/O Pin Counts
1. Introduction to this Handbook
2. Recommended Design Flow
3. Selecting Your Memory
4. Selecting Your FPGA Device

2.1.9. Compiling Your Design and Verifying Timing

When you compile your design, the Timing Analyzer generates timing reports for your design.
  1. Compile your design by clicking Processing > Start Compilation.
    Memory timing scripts run automatically as part of Report DDR.
  2. Verify timing closure using all available models, and evaluate the timing reports generated by the Timing Analyzer.
    As required, adjust the constraints described in Adding Design Constraints to resolve timing or location issues.
  3. Iteratively recompile your IP and evaluate the timing results as necessary to achieve the required timing margins.
Related Information
Level Two Title