External Memory Interface Handbook Volume 1: Intel® FPGA Memory Solution Introduction and Design Flow: For UniPHY-based Device Families

Download PDF
ID 710283
Date 3/06/2023
Public
Document Table of Contents
Document Table of Contents x
1. Introduction to this Handbook 2. Recommended Design Flow 3. Selecting Your Memory 4. Selecting Your FPGA Device
1. Introduction to this Handbook x
1.1. Introduction to Memory Solutions 1.2. Protocol Support Matrix 1.3. Document Revision History
2. Recommended Design Flow x
2.1. Getting Started With External Memory Interfaces 2.2. Document Revision History
2.1. Getting Started With External Memory Interfaces x
2.1.1. Selecting Your External Memory Device 2.1.2. Selecting Your FPGA 2.1.3. Planning Your Pin Requirements 2.1.4. Planning Your FPGA Resources 2.1.5. Determining Your Board Layout 2.1.6. Specifying Parameters for Your External Memory Interface 2.1.7. Performing Functional Simulation 2.1.8. Adding Design Constraints 2.1.9. Compiling Your Design and Verifying Timing 2.1.10. Verifying and Debugging External Memory Interface Operation
3. Selecting Your Memory x
3.1. DDR SDRAM Features 3.2. DDR2 SDRAM Features 3.3. DDR3 SDRAM Features 3.4. QDR, QDR II, and QDR II+ SRAM Features 3.5. RLDRAM II and RLDRAM 3 Features 3.6. LPDDR2 Features 3.7. Memory Selection 3.8. Example of High-Speed Memory in Embedded Processor 3.9. Example of High-Speed Memory in Telecom 3.10. Document Revision History
4. Selecting Your FPGA Device x
4.1. Memory Standards 4.2. I/O Interfaces 4.3. Wraparound Interfaces 4.4. Read and Write Leveling 4.5. Dynamic OCT 4.6. Device Settings Selection 4.7. Document Revision History
4.6. Device Settings Selection x
4.6.1. Device Speed Grade 4.6.2. Device Operating Temperature 4.6.3. Device Package Size 4.6.4. Device Density and I/O Pin Counts
1. Introduction to this Handbook
2. Recommended Design Flow
3. Selecting Your Memory
4. Selecting Your FPGA Device

2.1.3. Planning Your Pin Requirements

Before you can specify parameters for your external memory interface, you must determine the pin requirements. You should use the Intel® Quartus® Prime software for final pin fitting; however, you can estimate whether you have enough pins for your memory interface.
  1. Determine how many read data pins are associated per read data strobe or clock pair.
  2. Check the device density and packaging information for your FPGA to determine whether you can implement your interface in one I/O bank, or on one side of the device, or on two adjacent sides.
  3. Calculate the number of other memory interface pins needed, including any other clocks (write clock or memory system clock), address, command, RUP, RDN, RZQ, and any other pins to be connected to the memory components. Ensure you have enough pins to implement the interface in one I/O bank or one side or on two adjacent sides.
  4. Apply the General Pin-Out Guidelines, and observe any device- or protocol-specific guidelines or exceptions applicable to your design situation.
Related Information
Level Two Title