DisplayPort Intel® Cyclone 10 GX FPGA IP Design Example User Guide

ID 683603
Date 9/02/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

2.8. Hardware Setup

The DisplayPort Intel® FPGA IP design example is 4Kp60 capable and performs a loop-through for a standard DisplayPort video stream.
  1. To run the hardware test, connect a DisplayPort-enabled source device to the DisplayPort FMC daughter card sink input.
  2. The DisplayPort sink decodes the port into a standard video stream and sends it to the clock recovery core.
  3. The clock recovery core synthesizes the original video pixel clock to be transmitted together with the received video data.
    Note: You require the clock recovery feature to produce video without using a frame buffer.
  4. The clock recovery core then sends the video data to the DisplayPort source and the Transceiver Native PHY TX block.
  5. Connect the DisplayPort FMC daughter card source port to a monitor to display the image.
Table 21.  On-board User LED Functions
LEDs Function
USER_LED[0]

This LED indicates that the source is successfully lane-trained.

At this point, the IP core asserts rx0_vid_locked.

USER_LED[1]

This LED indicates that the source Transceiver PLL is locked at the link training data rate.

USER_LED[3:2] These LEDs indicate the RX link rate.
  • 2'b00 = RBR
  • 2'b01 = HBR
  • 2'b10 = HBR2
  • 2'b11 = HBR3