DisplayPort Intel® FPGA IP User Guide

ID 683273
Date 9/02/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

6.6.9. Secondary Stream Interface

The secondary streams data can be received through the rxN_ss interfaces. The interfaces do not allow for back-pressure and assume the downstream logic can handle complete packets. The rxN_ss interface does not distinguish between the types of packets it receives.

Note: The DisplayPort Intel® FPGA IP supports InfoFrame SDP versions 1.2 and 1.3 over the Main-Link. INFOFRAME SDP version 1.2 shall be used to convey Audio INFOFRAME control information, as specified in CEA-861-F and CEA-861.2. Other INFOFRAME coding types, as specified in CEA-861-F, Table 5, and CEA-861.3, shall use INFOFRAME SDP version 1.3. Refer to the VESA DisplayPort Standard version 1.2a, Section 2.2.5.1 for detailed definition.

The format of the rxN_ss interface output corresponds to four 15-nibble code words as specified by the VESA DisplayPort Standard version 1.2a, Section 2.2.6.3. These 15-nibble code words are typically supplied to the downstream Reed-Solomon decoder. The format differs for both header and payload, as shown in the following figure.

Figure 37. rxN_ss Input Data Format

The following figure shows a typical secondary stream packet with the four byte header (HB0, HB1, HB2, and HB3) and 32-byte payload (DB0, ..., DB31). Each symbol has an associated parity nibble (PB0, ..., PB11). Downstream logic uses start-of-packet and end-of-packet to determine if the current input is a header or payload symbol.

Data is clocked out of the rxN_ss port using the rx_ss_clk signal. This signal is the same phase and frequency as the main link lane 0 clock.

Figure 38. Typical Secondary Stream Packet

The PB* fields of the Secondary Stream interface contain different information depending on the specific channel coding. 8B/10B SDPs carry the Parity Byte while 128B/132B typically carries zeros (0). When SDP CRC16 is enabled for 128B/132B Channel Coding, the fields for PB8, PB9, PB10, and PB11 contains the CRC16 values instead of zeros (0).